![]() And make sure that you do not lift up on the toilet at any time, or you'll have to pull the entire thing up and replace the wax seal. I usually can't get it tight enough with my bare hands, and give it an extra quarter turn with a socket, but do so carefully. Connect a water supply hose or pipe to the water supply valve followed by the inlet on the underside of the toilets tank. ![]() ![]() Wrap the threads on the water supply valve, located on the wall or floor, and the toilet tank inlet with plumbers tape. Hand tighten the nut, since using a socket wrench can case the porcelain to crack. Insert the tank bolts through the bottom of the tank and secure from beneath with the tank nuts. Remove the nut and washer, reinstall the base of the cap, the washer, and then the nut. Install toilet tank bolts everbuilt how to Prime and apply cement to the free end of the soil pipe and the inside of the closet flange. I'd drain the toilet tank (shutoff the water and flush) to minimize the risk that the toilet will tip when you unbolt it from the floor. To fix this, you'll want a new cap with the proper base. When you're done, you cut off the excess bolt with a hack saw, which will leave a rough edge. For reinforced connection: Under tank, place metal washers on thin hex nuts and hand tighten to toilet tank. ![]() Toilet bolts come fairly long to allow for different thicknesses of flooring and to allow you to thread the bolt before you've pushed the wax seal flat (to ensure you're lined up). Place tank bolts through bottom holes of tank. It looks like the contractor forgot about those, or possibly you have a style that doesn't require it and it snaps on a different way.Īs for the sharp edges on the bolt, that's normal. ![]() This is what the cap snaps onto, and without it, it won't stay down securely. The snap on caps often come with a plastic piece that goes under the washer. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |